V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
-
the lever
-
the nut, lock washer and rubber seal from the gear-shift position sensor
-
the nut for the mounting for the cable duct
-
remove the tie straps
-
lift the cable duct to one side
-
the two screws for the gear-shift position sensor.
Carefully lift the sensor off the gear shift linkage rod.
Replacing the sealing ring for the gear shift linkage rod
Remove the old sealing ring. Use a small rounded off screwdriver.
Take care not to damage the rod.
Smear a little automatic transmission fluid on the new sealing ring. Install the ring. Use drift 999 5476.
Installation
Installing the gear-shift position sensor
-
Tighten the sensor screws lightly
-
Install the rubber washer, lock washer and the nut on the gear shift linkage rod connection
-
Tighten the nut
-
Lock the nut using the lock washer
-
Install new tie straps.
Adjusting the gear-shift position sensor
See Checking and adjusting the gear-shift position sensor.
Installing the gear-shift position sensor, continued