V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Lubricate the edges of the new seal using automatic transmission fluid.
Install locating pin 999 5769 Pilot See: Tools and Equipment/999 5769 Pilot.
Install the seal on the locating pin. Use drift 999 5771 Drift See: Tools and Equipment/999 5771 Drift.
Tap in the seal until the drift is against the transmission.
Remove the locating pin.
Check the oil level according to Checking and adjusting the oil, AW55-50/51SN See: Service and Repair/Procedures/Checking Oil Level.
Install the drive shaft according to Drive shaft right-hand side, replace, AW55-50/51SN See: Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Removal and Replacement/Drive Shaft Right-Hand Side, Replace.
Install the central front-rear member and cross stay.
(Applies only to USA) Install the central front-rear member and cross stay according to Replacing the cross member, AW55-50/51SN See: Body and
Frame/Frame/Cross-Member/Front Cross-Member/Service and Repair.
Replacing The Sealing Ring For The Oil Pump
Replacing the sealing ring for the oil pump
Special tools:
999 5069 EXTRACTOR See: Tools and Equipment/999 5069 Extractor
999 5117 PUNCH See: Tools and Equipment/999 5117 Punch
Note! The illustrations in this service information are used for different model years and / or models. Some variation may occur. However, the
essential information is always correct.
Removing
Removing the transmission
Remove the transmission according to Replacing the transmission, AW55-50/51SN See: Service and Repair/Removal and Replacement/Replacing The
Transmission.
Removing the torque converter
Pull the torque converter straight out of the transmission. Check the torque converter throat for damage.
Removing the sealing ring from the oil pump