V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Knock the knob into place using a plastic mallet to avoid marking the knob.
Check
Function
-
Check that the lock arm does not catch on the gear sector when the lever is moved forwards and backwards
-
Start the engine.
Check that the catch for the retaining brake is functioning correctly by moving the lever into the retaining brake position and moving the gear selector
into the drive position (D).
The car must remain stationary.
Tightening torques
The screw for the brake and throttle arm must be tightened. Tighten to 8 Nm.
Note! Apply Loctite Normal to the screw
Replacing Gear Selector Assembly
Replacing the gear selector assembly
Removal
Removing center consoles
-
To remove the front center consoles, see Front center console See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Removal and Replacement/Front Center Console
-
To remove the rear center consoles, see Rear center console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal
and Replacement/Rear Center Console
-
Remove the lamp holder from the lighting strip
-
Disconnect the connector from the winter mode switch
-
Remove the gear selector knob according to Replacing gear selector knob, AW55-50/51SN See: Replacing Gear Selector Knob.
Removing gear selector assembly