V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Disconnect the transmission cable from the gear selector assembly.
Use flat-nosed pliers to remove the cable pin.
Remove:
-
the 4 screws for the gear selector assembly
-
the clips for the cable harness (from the reverse). Disconnect the connectors
-
the gear selector assembly.
Caution! Take care not to bent the transmission cable.
Installation
Installing gear selector assembly and transmission cable
Certain models have a keylock and a shiftlock solenoid.
Install the keylock cable according to Replacing the key lock cable, AW55-50/51SN See: Shift Interlock/Shift Interlock Cable/Service and
Repair/Removal and Replacement.
Installing the shiftlock solenoid and micro-switch according to Replacing the shift lock solenoid and micro-switch, AW55-50/51SN See: Actuators and
Solenoids - A/T/Shift Interlock Solenoid/Service and Repair/Removal and Replacement.
Install:
-
the gear selector assembly (4 screws). At the same time locate the cable in the gear selector assembly.
Tighten to: 25 Nm
Caution! do not damage the cable or sleeve by bending it excessively
-
the clips for the cable harness (from the reverse). Install the connectors
-
the cable sleeve in the gear selector assembly and press it into place
-
the cable on the gear selector with the pin.
Caution! Take care not to damage the cable or sleeve by bending it excessively.
Installing center consoles
-
Install the front center console according to Front center console See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Removal and Replacement/Front Center Console