V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
Remove:
-
the retaining clip from the lever
-
the cable from the lever
-
the lever from the gear shift linkage rod
-
the screw for the gear selector sensor and cable harness.
Twist out the tab on the cable harness holder.
Note! The following only applies when replacing the control system.
Set the transmission lever to the neutral position. Move the lever as far forward as possible to position P and then back two steps to neutral.
Opening the control system
Remove the Torx TX40 screws for the control system cover.
Clean the sealing compound from the threads. Use tap M8 * 1.25.
Remove the cover.
Use tool 999 5477 JOINT WEDGE See: Tools and Equipment/999 5477 Joint Wedge. Tap the tool carefully into the joint between the cover and the
transmission to ensure that the cover sealing flange is not distorted. Take care not to damage the oil temperature sensor cables.
Clean the gasket residue from the cover and the transmission. Use a scraper.
Note! Ensure that no debris enters the transmission. Wash the cover thoroughly.
