V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
If the constant velocity joint has a visible snap ring, the snap ring must be held open and the constant velocity joint released. See Releasing constant
velocity joint with visible snap ring. The snap ring is visible in a cut-out on the inner ring.
Drive shaft without visible snap ring. Tap off the constant velocity joint housing
Use a brass drift.
Note! Only tap the inner ring. Take care not to damage the ball holder or outer ring.
Inner boot
If replacing both drive shaft boots, replace the inner boot according to Releasing constant velocity joint with visible snap ring.
Cleaning the constant velocity joint
Note! The joint can be cleaned when assembled and blown clean before greasing.
For disassembly and inspection, see Cleaning and checking the outer constant velocity joint.
Lubricating the constant velocity joint