V40 L4-1.9L Turbo VIN 29 B4204T3 (2002)
-
Release the control mechanism (press off the drive mechanism ball with a large screwdriver).
-
Remove the mounting nuts (x 6) from the windscreen wiper shafts.
-
Remove the assembly. Replace the control arms and /or shafts.
-
Grease the ball joints (grease P/N 1161037-5).
-
Install the assembly. Tighten the nut to 10 Nm.
Hint: Ensure that the turn points under the shafts are correctly located!
-
Install the panel (7 x mounting screws).
-
Install the wiper arm, see Windshield wiper arm See: Wiper Arm/Service and Repair/Removal and Replacement.
-
Check the function.
Tailgate Wiper Mechanism And Motor
Tailgate wiper mechanism and motor
Preparations
-
Switch on the ignition.
-
Check that the wiper motor is in the parked position.
Switch the rear windshield wiper on and off.
-
If the wiper motor is not functioning, see Replacing the tailgate wiper motor.
-
Switch off the ignition.
Removing the tailgate wiper mechanism