V50 L5-2.4L VIN 38 B5244S4 (2006)
-
Take the ball holder, towing ball, washer, nut, locking bolt and cotter pin from the kit
-
Slide the ball holder into the square mounting for the towing ball. Slide until the holes in the ball holder and the square mounting are aligned
-
Slide the locking bolt into the hole
-
Lock the other side using the cotter pin
-
Position the ball in the hole on the ball holder
-
Install the washer and nut. Tighten to 244 Nm (180 lbf. ft.).
Storing the tow hitch, applies to cars without a spare wheel
Illustration A
-
Place the tow hitch and test the position
-
Clean the surfaces where the pieces of foam tape will be applied
-
Screw the screw fully into the polystyrene box.
Illustration B
-
Apply the pieces of foam tape from the kit. See the illustration.