V50 L5-2.4L VIN 38 B5244S4 (2006)
-
Unscrew the screw with the plastic cone holding the spare wheel
-
Lift out the spare wheel.
-
Place the spacer block with the large hole (from the kit) in the centre of the bottom of the spare wheel well with the angled lug (1) facing forward
in the car
-
Using a pencil, mark the insulation panel at the bottom of the spare wheel well along the edge of the hole
-
Remove the spacer block.
-
Cut just inside the marking so that the underneath of the spacer block lies against the bottom of the spare wheel well. Ensure that none of the
insulation panel is in between the spacer block and the wheel well
-
Reposition the spacer block.