V50 L5-2.4L VIN 38 B5244S4 (2006)
-
Remove the screw (2) at the front/top edge of the side panel.
-
Pull off the side panel at the top so that the two clips at the rear/bottom of the side window and the clip at the bottom of the D-post release.
-
Disconnect the connector for the 12V socket, if present.
-
Lift out the side panel.
-
Remove the right-hand floor support. First remove the three clips at the bottom of the compartment, then lift it up.
Applies to cars with Parking Assistance Module (PAM)
-
Remove the Parking Assistance Module (PAM) with cables behind the right-hand wheel arch. This is done to make space for installing the
Accessory Electronic Module (AEM).
-
If necessary: disconnect any surrounding wiring.
-
Remove the insulation panel. The insulation panel is secured with two clips.