V50 L5-2.4L VIN 38 B5244S4 (2006)
Cut off the wires as close as possible to the terminals in the connector in the A-pillar.
Installing cable harness in A-pillar
Splice in the new water-proof cable harness (the small cable harness is only used for the left door).
Caution!
Make sure that you splice the correct wire, color to color.
Splicing wire, see VIDA: Information> Repair> Removal, replacement and installation > 3 Electrical system> 37 Cables and fuses > Wiring > Joining
cables
Cut the different wires at different lengths, to avoid that all splice connections end up in the same place, creating too thick a bunch of wires.
Install the new cable harness in the A-pillar. The 16-pin cable harness must be installed forward in the vehicle.
Removing door panel
Remove the door panel. Pull the door panel straight out. It is secured with 9 clips.
Removing plastic conduit