V50 L5-2.4L VIN 38 B5244S4 (2006)
Finishing
Installing components
Install:
-
the gear selector knob. See: Knob, gear shift selector See: Knob, Gear Shift Selector
-
the center console. See: Floor console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console Floor console
See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console.
Note! Calibrate the integrated position sensor, which is in the gear lever assemble, once the unit has been replaced or has been disconnected.
When replacing the position sensor, the new position sensor must be calibrated. Carry out calibration according to VIDA Vehicle communication,
Function area 4 transmission control module (TCM).
Selector Lever Assembly
Selector Lever Assembly
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Preparatory work
Removing the center console
Remove center console. See: Floor console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console Floor console
See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console.
Removal
Removing the gear selector assembly
Disconnect the cable harness.
Remove the 4 x M8 screws.