V50 L5-2.4L VIN 39 B5244S7 (2005)
Applicable when installing new treble loudspeakers
-
Carefully pry out the existing treble loudspeaker. Use a small screwdriver. It is secured by five catches
-
Take out the new treble loudspeaker and cable harness. Insert the cable harness at the front edge of the hole in the bracket for the treble
loudspeaker. There is limited space in the hole, but there is just enough room for the connector to pass through. Route the cable harness on the
inside of the door panel so that the cable harness is between the door panel and the air duct
-
Align the treble loudspeaker in the hole. Press the treble loudspeaker into place. Ensure that all the mounting hooks have secured
-
Route the cable harness from the reverse of the air duct. Connect the connector to the pre-routed connector in position (1) when reinstalling the
door panel.
Applies to all models
-
Connect the connector to the door opener
-
Connect the connector to the treble loudspeaker
-
Reconnect the mechanical cable and socket to the door opener
-
Press the door panel into place. Secure the door panel using the three screws
-
Connect the connector to the door module. Press the panel with the door module into place in the door panel. Ensure that all the mounting hooks
have secured
-
Reinstall the small panel in the door handle panel
-
Reinstall the small panel in the front/upper edge of the door
-
Repeat points 1-7 on the other side.
Loudspeaker, Rear Side Door
Loudspeaker, rear side door
