V50 L5-2.4L VIN 39 B5244S7 (2005)
-
Disconnect the fibre optic cable (1) from the underside of the amplifier.
Illustration B
-
Take the T-fibre optic cable (B in the kit illustration) from the kit. Connect the long end (1) to the subwoofer.
-
Connect the connector (2), which was disconnected from the amplifier, to the female terminal (3) on the T-fibre optic cable.
-
Connect the remaining connector (4) on the T-fibre optic cable to the amplifier.
-
Secure the cable splice terminals to the fibre optic cables (1) using the clip (2) for the panel edge.
Note! Do not bend the fibre optic cable too tightly.
-
Check the bend radius of the fibre optic cables. If the bend radius is less than 25 mm (1"), remove the tape from the thick cable harness and
increase the radius.
-
Continue to step 50.
Steps 45-47 apply to US cars with RTI, and EU cars with RTI and CH -78748
