V50 L5-2.4L VIN 39 B5244S7 (2005)
Applies to cars with a low cargo compartment floor
-
Take the right-hand floor support (H in the kit illustration) from the kit and install it using the existing clips.
For cars with a high cargo compartment floor
-
Reinstall the right-hand floor support.
Applies to cars with grocery bag holder on the cargo compartment floor
-
Install the adapter in the intended socket in the sill moulding.
Reinstall:
-
the insulation panel
-
the side panels. Tighten using the screw at the front edge. Tighten the screws for the load securing eyelets. Tighten to 24 Nm (18 lbf.ft.). The
screw is the same screw as that for the subwoofer rear mounting.
-
the covers for the load securing eyelets.
-
the lower panels on the C-post
-
the rubber strip at the rear edge of the opening for the rear doors
-
the panels at the front/top of the side panels. Press downwards so that the catches engage. Tighten using the screw
-
the side cushions
-
the rubber strip on the sides in the tailgate opening
-
the sill trim panel for the tailgate.
-
Reinstall the cargo compartment carpet
(If it is a cargo compartment carpet with grocery bag holder then its two knobs should be in the corresponding holes in the adapter.)
-
Fold the backrests and seat cushions back into place.
-
Programme the software in accordance with the service information in VIDA.
