V50 L5-2.4L VIN 39 B5244S7 (2005)
-
Fit the cable with the clips.
-
Applies to keyless cars: Attach the connector to the antenna, Keyless Vehicle Module (KVM).
-
Applies to others: Attach the connector with a tie strap so that it does not rattle.
Applies to cars with towbar
Illustration A
-
Detach the towbar wiring connector from the Trailer Module (TRM).
-
Detach all cables from the connector and pull the cables out through the rubber grommet. The number of cables may vary depending on the towbar
wiring used.
-
Remove the rubber grommet, it shall not be re-used.
Illustration B applies to keyless cars
-
If the car is keyless then the cable (1) must be detached at both ends and removed. It shall not be re-used. The cable is internally connected to a
grey connector below the right-hand rear lamp.