V50 L5-2.4L VIN 39 B5244S7 (2005)
-
Refit the rubber mounting.
-
Remove the support from under the silencer.
-
Install the tow hitch wiring following separate installation instructions.
Illustration A
Applies to cars without body kit
-
Apply tape to the outside of the bumper cover, opposite the marking (1) on the inside. This is done to protect the paint from the saw when cutting
out the cut-out for the towbar.
-
Cut out the cut-out following the existing marking. The marking on the bumper cover is only a thin line.
Note! Do not damage the painted surface of the bumper cover.
-
Smooth off the sawn edges with a fine toothed file or knife. Remove the tape.
Illustration B
Applies to cars with body kit
-
On older spoilers this mark does not exist. Therefore, make a mark as follows: Height 100 mm, start from the mark to the left in the image (1).
