V50 L5-2.4L VIN 39 B5244S7 (2005)
-
Unscrew the two external clips at the front edge/bottom edge of the sill trim panel on the tailgate.
-
Pry up one of the corners of the sill trim panel using a weatherstrip tool so that the two clips at that end release.
-
Pull up the sill trim panel at the other end so that the remaining two clips release. Remove the sill trim panel.
-
Detach the rubber strip where it covers the right-hand side panel in the tailgate opening.
-
Remove the three clips (1) that hold the right-hand side panel in the bodywork.
-
Unhook the side panel from the mounting (2) on the underneath of the parcel shelf.
-
Fold out the rear edge of the side panel from the bodywork. At the same time unhook the side panel from the rear load securing eyelet. If the car
has a 12V socket in the side panel, disconnect the connector from this socket (if applicable).
-
Fold out the side panel to access the space in the rear of the wheel arch.
Installing the control module
-
Clean the marked surfaces on the inside of the rear display screen using isopropanol, and wipe dry.