V50 L5-2.4L VIN 39 B5244S7 (2005)
Applies to cars from CH 40000-, with Parking Assistance Module (PAM)
-
Detach the green (GN) five pin connector (1) which is taped at the Parking Assistance Module (PAM) cable's rubber grommet.
-
Plug the green connector into the Trailer Module (TRM).
Applies to V50s manufactured after w720
-
Pull up the catch on the cover on the fuse box in the engine compartment. Pull up the cover and remove it.
Applies to V50s manufactured after w720
-
Take a 40 A fuse from the kit and install it in terminal 14 in the fuse holder.
-
Reinstall the cover.
Finishing work
-
Reinstall the insulation panel.
-
Refit the Parking Assistance Module (PAM), if the car is equipped with one. Refit any other detached cables.
-
Reinstall the side panel. If the car has a 12V socket, connect the connector to this.
-
Tighten the screws for the load securing eyelets. Tighten to 24 Nm (18 lbf.ft.).
-
Reinstall the panel at the front/top of the side panel. Press downwards so that the catches engage. Tighten using the screw.
-
Reinstall the C-post panel.