V50 L5-2.4L VIN 39 B5244S7 (2005)
The surround for the cover (2) for the mass movement sensor (MMS). It is hot-bonded outside the vehicle.
The rear foam block by the reading lamp. It is hot-bonded outside the vehicle.
Transferring components that are to be taped
Use tape P/N 951 1099.
Tape the washer hoses in place outside the vehicle, or together with the cable harness inside the vehicle.
Tape the cable harness in position in the vehicle.
Installation
Note! For tightening torques, see Specifications. See: Specifications
Installing the headlining
Install the sun roof molding (if applicable) on the sun roof frame.
Note! Use a new molding.
Insert the headlining through the windshield opening.
Tape the cable harness to the headlining. See the previous instructions for transferring components.
Install:
-
the cover for the mass movement sensor (MMS)
-
the rear interior lighting acc. to Rear interior light See: Lighting and Horns/Dome Lamp/Service and Repair/Rear Interior Light
-
the 1 clip. Press into place
-
the M6 screws, 1 for each mounting, for the front and rear cargo net mountings (if applicable). Tighten
-
the grab handles, 2 screws per handle. Tighten
-
the washer hose at the A-post. Press into place
-
the washer hose at the cantrail panel. Press into place
-
the D-post panel. See: Panel, D-pillar See: Trim Panel/Service and Repair/D-Pillar Panel
-
the C-post upper panel. See: C-pillar trim panel See: Trim Panel/Service and Repair/C-Pillar Trim Panel
-
the A-post panel. See: A-pillar trim panel See: Trim Panel/Service and Repair/A-Pillar Trim Panel
-
the front courtesy lighting. See: Lighting, internal front See: Lighting and Horns/Dome Lamp/Service and Repair/Lighting, Internal Front
-
the sun visors. See: Sun visor See: Sun Visor/Service and Repair/Sun Visor