V50 L5-2.4L VIN 39 B5244S7 (2005)
Note! The front guide holes (1) for the locating pins for the clips must be no larger than 3.5 mm (9/64").
-
Measure the holes for the clips for the front end of the net pocket in the side panel. Apply a wide piece of tape over the area where the holes are to
be marked. Make the markings on this tape. The horizontal dimensions must be measured outwards from the centre (1) of the curvature. The
vertical dimensions must be measured from the flat, lower section of the panel
-
Press holes into the panel at the markings using a scriber.
Note! The guide holes (1) for the locating pins for the clips must be no larger than 3.5 mm (9/64").
-
Remove the cargo compartment carpet.
-
Pry off the four external clips at the front edge/bottom edge of the sill trim panel on the tailgate
-
Pry up one of the corners of the sill trim panel using a weatherstrip tool so that the two clips at that end release
-
Pull up the sill trim panel so the remaining six clips release. Remove the panel
-
Detach the rubber strip where it covers the left-hand side panel in the boot opening.
