V50 L5-2.4L VIN 39 B5244S7 (2005)
-
Install the ISOFIX mounting, from the kit, over the weld nuts. Tighten the mounting using the two screws. Tighten to 40 Nm (30 lbf.ft.).
-
Fold the floor carpet back into place and insert the ISOFIX mounting's eyelets in the two cut-outs. Insert the rear edge of the floor carpet under the
floor support. If necessary, pry up the floor support to make room.
-
Reinstall the backrest. Tighten the screws to 40 Nm (30 lbf.ft).
-
Reinstall the side bolster.
-
Fold the seat cushion back into place.
Steps 7-19 apply to the C30
-
Pull off the seat cushion, first at the rear edge where it is secured by one holder. Then at the front edge where it is secured by two holders.
-
Remove the seat cushion.
