V50 L5-2.4L VIN 39 B5244S7 (2005)
Check brake disc friction surfaces.
If the brake disc displays signs of out-of-true, check its lateral run out. See: Brake disc front, checking See: Brake Rotor/Disc/Testing and
Inspection/Brake Disc Front, Checking.
Replace the brake disc if it displays signs of heavy wear, variable thickness or similar. To replace, see: Front brake disc See: Brake Rotor/Disc/Service
and Repair/Front Brake Disc, Replacing.
Note! Minimum disc thickness/replacement limit = 23.0mm. Minimum recommended disc thickness when installing new brake pads = 23.8mm.
Installing brake pads
Note! For tightening torques, see Specifications. See: Specifications/Tightening Torque
Lubricating the sliding surfaces
Lubricate the contact surfaces of the brake pads using silicone grease, part no. 1161687 (12 ml) or part no. 1161688 (50 ml).
(Do not lubricate the sliding pins)
Installing brake pads
Press piston back into cylinder on brake caliper.
Check that the dust cover is correctly positioned.
Install:
-
new brake pads
-
the brake caliper
-
the locating pins. Tighten in accordance with: Tightening torque See: Specifications/Tightening Torque.
Note! Check the rubber sleeves of the locating pins. Replace if necessary.
-
the protective caps
-
the spring.
Finishing
Depress the brake pedal a few times. Check the brake fluid level in the reservoir. Top up if necessary.
Install the wheel. See: Wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair.