V50 L5-2.4L VIN 39 B5244S7 (2005)
Lubricate the surface of the seal that the camshaft rotates against. Install the camshaft seal.
For camshafts with variable valve timing:
Use: 999 5718. Use the mounting screw for the variable valve timing unit. Tighten until the drift bottoms out.
For camshafts without variable valve timing:
Use: 999 5719. Use the screws for the timing belt wheels to pull in the drift until it bottoms out.
Removing the starter motor
Lift the coolant hose out of the holder/bracket.
Remove:
-
the nuts for the coolant hose bracket. Bend the bracket to one side to access the screws for the starter motor
-
the flat pin contactor and the positive cable from the starter motor
-
the screws holding the starter motor against the transmission. Lift out the starter motor.
Installing the crankshaft adjustment tool
Caution: Ensure that the tool bottoms out against the cylinder block.
