V50 L5-2.4L VIN 39 B5244S7 (2005)
Fit the sump and install all screws.
Caution! Check that the trailing edge of the oil sump is in line with the trailing edge of the engine block. Permitted tolerance is ± 0.025 mm. Use
a steel ruler and a feeler gauge.
Tighten the screws from the oil sump's trailing edge and forward.
Installing rear crankshaft seal
Use: 999 1801 STANDARD SHAFT See: Tools and Equipment/999 1801 Standard Shaft and 999 5676 Drift replaced by 9997174 See: Tools and
Equipment/999 5676 Drift Replaced By 9997174
Lube the drift's sliding surface with oil and fit the seal on the drift.
Tap in the seal until the drift stops against the engine block.
