V50 L5-2.4L VIN 39 B5244S7 (2005)
Muffler: Service and Repair
Muffler, Center
Muffler center
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Removal
Removing the muffler
Note! If a joint is missing between the center and rear mufflers, both must be replaced.
Applies at the first change
Cut between the front and center exhaust pipe to create an 85 mm pipe sleeve. Measure from the rear end of the front muffler. See A.
Remove:
-
the M10 nut for the clamp between the rear and center muffler
-
the rubber mountings from the muffler
-
the center muffler.
Applies to the second or later changes
Remove:
-
the M10 nut for the clamp between the front and center muffler
-
the M10 nut for the clamp between the rear and center muffler
-
the rubber mountings
-
the muffler.
Hint: Tap carefully around the joint to crack any rust and soot deposits in the joint. Use a hammer.
Installation
Note! For tightening torques, see Specifications. See: Engine/Specifications/Mechanical Specifications/Tightening Torque