V50 L5-2.4L VIN 39 B5244S7 (2005)
Applies to cars from CH 40000-, with Parking Assistance Module (PAM) without a tow hitch
-
Detach the green (GN) five pin connector (1) which is taped at the Parking Assistance Module (PAM) cable's rubber grommet.
-
Plug the green connector into the Accessory Electronic Module (AEM).
-
Fit the Accessory Electronic Module (AEM) in place and tighten the two screws.
-
Position the wiring inside the panel at the rear wing.
-
Reinstall the soundproofing panel.
-
Refit the Parking Assistance Module (PAM), if the car is equipped with one. In addition, refit any detached cables.
-
Reinstall the floor support.
-
Reinstall the side panel. Tighten using the screw at the front edge. Tighten the screws for the load securing eyelets. Tighten to 24 Nm (18 lbf. ft.).
-
Reinstall the lower C-post panel.
-
Reinstall the rubber strip at the rear edge of the opening for the rear door.
-
Reinstall the panel at the front/top of the side panel. Press downwards so that the catches engage. Then tighten using the screw.
-
Reinstall the side cushion.
-
Reinstall the rubber strip in the boot lid opening.
-
Reinstall the sill trim panel for the tailgate.
-
Reinstall the cargo compartment carpet.
-
Fold the backrest and seat back into place.
-
Program the function using VCT2000.
Points 18-32 apply to S40 (04-)
-
Remove the cargo compartment carpet.