V50 L5-2.4L VIN 39 B5244S7 (2005)
5: Piston with slits
6: Return spring
A: Channel leading to chamber A1 in the CVVT unit
B: Channel leading to chamber B1 in the CVVT unit
C: Channel for oil (pressure)
D: Channel for oil (return)
The camshaft reset valve controls the oil flow to the continuous variable valve timing (CVVT) unit. The engine control module (ECM) uses a pulse
width modulation (PWM) signal to control the valve.
Control takes place as follows when deploying the camshaft
HINT: The illustration is a view of the CVVT unit from the side and from the rear.
-
The oil is forced from the engine lubrication system (C)
-
The valve is grounded by the engine control module (ECM). The oil flows via the slits in the piston (5) to the oil channel (A) in the camshaft
-
The oil flows via oil channels in the camshaft to the top of the lock pin (2). If the camshaft is in its 0 position, the lock pin will be forced in by the