Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V50 L5-2.4L VIN 39 B5244S7 (2005)

Relays and Modules > Relays and Modules - Accessories and Optional Equipment > Communications Control Module > Component Information > Testing and Inspection > Initial Inspection and Diagnostic Overview > Page 333

Page 19
background image

modules in the vehicle is that the driver information module (DIM) is active and can be communicated with. If communication is not possible with the
driver information module (DIM), check the voltage feed and ground for the control module.

VCT2000 and cable harness

-

Connect VCT2000 to the vehicle so that it is supplied with voltage. Test VCT2000 by selecting the system's self-test and VCT Test in the VIDA
main menu. If any malfunction is found according to the test, first replace the cable harness then the VCT2000, if the test still indicates a
malfunction.

-

If no malfunctions were found after troubleshooting according to above, try with a new cable harness and/or new VCT2000.

VIDA

-

If no malfunctions were found after troubleshooting according to above, try performing a complete system reset of VIDA.

Other information

-

Checking wiring and terminals See: Testing and Inspection/Component Tests and General Diagnostics/Checking Wiring and Terminals 

Relays and Modules > Relays and Modules - Accessories and Optional Equipment > Communications Control Module > Component Information > Testing and Inspection > Initial Inspection and Diagnostic Overview > Page 333

[PREV PAGE] [NEXT PAGE]