Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V50 L5-2.4L VIN 39 B5244S7 (2005)

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Body Control Module > Component Information > Service and Repair > Accessory Control Module (AEM) > Page 1528

Page 6
background image

-

Remove the screw (2) at the front/top edge of the side panel.

-

Pull off the side panel at the top so that the two clips at the rear/bottom of the side window and the clip at the bottom of the D-post release.

-

Disconnect the connector for the 12V socket, if present.

-

Lift out the side panel.

-

Remove the right-hand floor support. First remove the three clips at the bottom of the compartment, then lift it up.

Applies to cars with Parking Assistance Module (PAM)

-

Remove the Parking Assistance Module (PAM) with cables behind the right-hand wheel arch. This is done to make space for installing the
Accessory Electronic Module (AEM).

-

If necessary: disconnect any surrounding wiring.

-

Remove the insulation panel. The insulation panel is secured with two clips.

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Body Control Module > Component Information > Service and Repair > Accessory Control Module (AEM) > Page 1528

[PREV PAGE] [NEXT PAGE]