Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V50 L5-2.4L VIN 39 B5244S7 (2005)

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Diagrams > Diagram Information and Instructions > Page 1717

Page 42
background image

See the illustration.
At the same time pull the cable carefully backwards.

Assembly

Assembling primary lock

Check that the cable terminal is undamaged.
Press the cable terminal into the housing.
Check that the seal is correctly positioned and that the cable terminal is properly locked by pulling carefully on the cable.

Assembling secondary lock

Press the secondary lock into place.

Connector Type 1

Connector type 1

Special tools:

951 2636 Terminal removal tool  See: Tools and Equipment/951 2636 Terminal Removal Tool 
951 2637 Terminal removal tool  See: Tools and Equipment/951 2637 Terminal Removal Tool 

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.

Disassembly

Disassembling secondary lock

Fold up the secondary lock (1), as illustrated. Use a radio screwdriver.

Disassembling primary lock

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Diagrams > Diagram Information and Instructions > Page 1717

[PREV PAGE] [NEXT PAGE]