V50 L5-2.4L VIN 39 B5244S7 (2005)
Applies to cars without towbar
Illustration A
-
Remove the rubber grommet from the hole in the car, it shall not be re-used.
Illustration B applies to keyless cars
-
For keyless cars, the cable (1) must be detached at both ends and removed. It shall not be re-used. The cable is internally connected to a grey
connector below the right-hand rear lamp.
Illustration C
-
Take the cable harness with rubber grommet from the kit. The cable harness has a taped rubber grommet with integrated cable for keyless cars.
-
Pull in the end with four connectors through the hole in the car and fit the rubber grommet.
-
Fit the connector (1) for the sensors in the designated location below the rear lamp. Make sure that the clip engages properly.
Illustration D. Cable installation