V50 L5-2.4L VIN 39 B5244S7 (2005)
Engine Speed Sensor: Service and Repair
Engine Speed (RPM) Sensor, Replacing
NOTE: The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential
information in the illustrations is always correct.
Preparatory work
Removal
Removing components
Remove the air cleaner (ACL) module.
Removing the intake manifold
CAUTION: Seal the openings in the lower part of the intake manifold. Use tape or similar.
Remove/slacken off the 6 screws for the upper intake manifold, the 2 screws closest to the front cover plate and the 2 screws against the firewall. Bend
up the intake manifold and hold it to one side.
Removing the engine speed (RPM) sensor
Remove the nut for the engine speed (RPM) sensor. Hold the radiator hose above the engine speed (RPM) sensor to one side. Disconnect the engine
speed (RPM) sensor connector. Lift up the engine speed (RPM) sensor.
Installation
NOTE: For tightening torques, see Specifications.
Installing the engine speed (RPM) sensor
CAUTION: Ensure that the guides for the lower section are in the correct position.
Install:
