V50 L5-2.4L VIN 39 B5244S7 (2005)
Use:999 7019 Lock key See: Tools and Equipment/999 7019 Lock Key to loosen the steering joint. Make sure that the puller rods you sue have the
same length.
Remove the steering joint from the steering gear.
Installing inner steering joint
Note! For tightening torques, see Specifications. See: Specifications
Install the tie rod. Use thread locker 1161053. Use:999 7019 Lock key See: Tools and Equipment/999 7019 Lock Key. Tighten according to: Tightening
torque See: Specifications
Remove the counterhold. Clean the rack after the tool has been removed and check that the rack is not damaged.
Install:
-
steering gear's rubber gaiter
-
lock nut, 1 pc., for outer steering joint
-
the 2 clamps
Note! Tape around the steering joint's thread to not damage the rubber gaiter.
Finishing
Install the outer steering joint and check/adjust wheel angles according to: Steering arm outer See: Steering Arm Outer.