V50 L5-2.4L VIN 39 B5244S7 (2005)
Constant Velocity Joint Boot: Service and Repair
Boot, driveshaft constant velocity joint, outer
Special tools:
999 5519
951 2619
999 7161
Note: The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential
information in the illustrations is always correct.
Removal
Caution! The constant velocity joint housing must not be disassembled.
Removing drive shafts
Remove the drive shafts.
Removing the boot
Secure the drive shaft in a vise with soft jaws.
Remove:
^
the clamps on the boot
^
the boot.
Wipe off any grease.
Measuring the tripod for the constant velocity joint housing.
Mark up the position of the tripod in relation to the constant velocity joint housing.
Remove by twisting the constant velocity joint housing and tapping the edge by the rollers so that the rollers detach, one at a time.
Use nylon or wooden shims.
Note: Take care when removing the tripod joint (needle bearing rollers).