V50 L5-2.4L VIN 39 B5244S7 (2005)
Liftgate Window Glass: Service and Repair
Rear window tailgate
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Removal
Removing the rear windshield
Remove:
-
the tailgate panels. See: Tailgate/trunk lid panel See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim
Panel/Service and Repair/Tailgate/Trunk Lid Panel
-
the stop lamp
-
the wiper motor
Disconnect rear windshield wiring.
Cut off approximately 5 m of wire from the roll.
Insert a wire inserter in the upper left-hand corner as illustrated.
Secure the wire and pull in the ends to the middle of the windshield.
Pull the wire around and downwards so it forms an eyelet around the outside of the windshield.
Check that the wire is at the bottom against the bead of adhesive.
Stretch the wire so it is still in position at the bottom. Pull in the excess from one end of the wire.