V70 L5-2.4L VIN 61 B5244S (2004)
-
Route the cable (1) under the carpet along the left side of the car to the rear door
-
Install the protective caps on the lugs (2) for the cable ducts
-
Route the cable further above and along the front cable duct (3). Continue along the right-hand side of the rear cable duct (4).
Illustration A applies to cars up to and including -2004 (CH -424999)
-
Connect the ground lead for the new shorter cable harness (1) to the rear ground terminal (2) under the seat cushion. Tighten to 10 Nm (7 lbf. ft.)
-
Route both the cables (1, 3) along the two cable ducts (4) under the insulation panel and out through the hole in the bodywork to the engine
compartment. Position the single pre-routed red/white (R/W) cables by the rear fuse holder
-
Disconnect the four connectors in the front cable duct. Position the wiring under these. Reconnect the connectors again.
Illustration B applies to cars from model year 2005- (CH 425000-)
-
Route the DIN cable (1) along the two cable ducts (2) under the insulation panel and out through the hole in the bodywork to the engine
compartment
-
Route the DIN cable under the four connectors in the front cable duct.
