V70 L5-2.4L VIN 61 B5244S (2004)
-
Remove the small insulation panel behind the fuse holder and place the panel to one side. It will not be used again.
-
Position both green connectors on the short cables and the red/white (R/W) single cable with the smaller cable terminal, backwards along the
cable. Insulate and secure them by the cable with foam tape from the kit so that they do not make contact with the chassis. The single cable with
the larger cable terminal and the long cable with green connector must be loose.
-
Connect the routed red/white cable to the outer position (1) on the reverse side of fuse socket 10 on the fuse holder. Remove the decal (2).
Carefully prize up the red secondary catch on the end face of the end closest to position 10 at the same time as the cable is pressed into place.
Hint: If there is a problem in routing the cable there then the fuses on the outer side must be removed so that the red secondary cable can be
opened further.
-
Reinstall the decal.
-
Install a 10A fuse in fuse socket 10 on the fuse holder.
