V70 L5-2.4L VIN 61 B5244S (2004)
Carry out in accordance with illustration A and B
-
Install the heat deflector plate (14) using the screw (12).
-
Loosely screw the heat deflector plate into place on the member (2) using the screw (1).
-
Bend the heat deflector plate using a screwdriver.
-
Fully screw in the screw.
-
Reinstall the rubber mounting (13) for the silencer. Use normal soap to facilitate installation.
-
Insert the member (1) between the brackets (4, 5) on the left and right-hand sides. Centre the holes.
-
Install the screws (2) and washers (14) from underneath the brackets (5) and the nuts (3) from above, without tightening.
-
Check that the distance between the member (1) and the spare wheel well is 10 mm (25/64") and centre the towbar against the car.
-
(The right-hand side is displayed - so the holes are on the left-hand side.) Tighten the screw (7). Tighten to 79 Nm (59 lbf.ft). Tighten the screws
(8). Tighten to 120 Nm (90 lbf.ft). Repeat the operation on the left-hand side.