V70 L5-2.4L VIN 61 B5244S (2004)
Applies to both sides, the right-hand side is illustrated (the holes are then on the left-hand side).
-
Tighten the screws (7) to 79 Nm (58 lbf.ft.).
-
Tighten the screws (8) to 120 Nm (88 lbf.ft.).
-
Tighten the screws (2) and nut (3) to 136 Nm (100 lbf.ft.).
-
Wait for at least five minutes so that the joint has time to set. Then tighten the screws (8) on both sides, a quarter turn (angle tightening 90°).
Note! Torque tightened screws that have been removed must not be reused.
-
Underseal.
Applies to Sweden only
-
Underseal after the state roadworthiness inspection.
Only applies if the car is equipped with mouldings
-
Reinstall the mouldings (3) on the expander clips. Press the mouldings into place.
Applies to all models
-
If the guide lugs (3) and clips (4) have loosened - reinstall them.