V70 L5-2.4L VIN 61 B5244S (2004)
CAUTION: Hold the drift straight when installing so that the sealing ring is pressed in to the same depth all the way around, reducing the likelihood of
leakage.
-
Thread the seal onto the beveled part of the inner section of 999 5676 with the felt side of the seal outwards
-
Install the drift on the crankshaft
-
Tap in the seal using the outer section of drift 999 5676. Use handle 999 1801. The seal is in position when the outer drift bottoms out against the
inner drift.
Installing flywheel and carrier plate
CAUTION: Ensure that the surface of the crankshaft and the mating surfaces for the flywheel/carrier plate are clean. Ensure that there is no thread
sealant residue in the screw holes.
Install:
-
the flywheel and carrier plate
-
the 3 studs 999 5678 distributed as shown in the above figure. Turn the short thread length towards the crankshaft.
NOTE: Check that the locating pin on the crankshaft is positioned opposite the hole in the flywheel/carrier plate. The position of the guide hole is
marked.
CAUTION: It is important that the flywheel and carrier plate bear on the crankshaft flange before the other screws are installed.