V70 L5-2.4L VIN 61 B5244S (2004)
Lubricate the camshaft lobes, the camshaft bearing surfaces and the top of the valve lifters.
Install the camshaft cover.
Install press tool 999 5454 PRESS TOOL See: Tools and Equipment/999 5454 Press Tool (2x).
Tighten the camshaft cover screws alternately, keeping it parallel to the cylinder head using the press tools.
Install all the screws. Tighten the screws from the middle and outwards.
Remove the press tools.
Install
-
the variable valve timing (VVT) solenoid. Use a new gasket
-
the spark plugs. Tighten to 30 Nm.
-
the hose for the water-heated crankcase ventilation to the thermostat housing. Tighten the clamp.
Connect the connector to the coolant temperature sensor.
Installing the intake pipe for the coolant pump
Install the inlet pipe for the coolant pump on the cylinder head. Use a new gasket.
Note! Apply thread sealant, P/N 116 056, to the screw threads.
Installing the rear camshaft seal