V70 L5-2.4L VIN 61 B5244S (2004)
Seals and Gaskets: Service and Repair
Input Shaft Seal
Input shaft seal
Special tools:
999 7003 Extractor primary shaft seal See: Tools and Equipment/999 7003 Extractor Primary Shaft Seal
999 7004 Drift primary shaft seal M56 See: Tools and Equipment/999 7004 Drift Primary Shaft Seal M56
Removal
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information is always correct.
Note! Preparations, see Transmission, Removing. See: Service and Repair/Removal and Replacement/Transmission, Removing
Removing the clutch cylinder
Remove the rubber seal from the clutch cover. Move it inwards on the pipe towards the clutch cylinder.
Pull out the retaining clip locking the quick-release connector on the pipe to the junction.
Remove the adapter. Keep it in a plastic bag to prevent contamination. Install a protective plug in the end of the pipe.
Remove the clutch cylinder.
Clean the mating surfaces in the clutch cover. Check any leakage from the gearbox.
Installing the extractor for the primary shaft seal
Tap in the extractor for the primary shaft seal.
Use puller 999 7003 Extractor primary shaft seal See: Tools and Equipment/999 7003 Extractor Primary Shaft Seal.
Note! The screw and socket must be unscrewed when tapping on the extractor.
Tap the tool into the seal. Tighten the inner socket. Counter hold the outer part at the same time so that the tool expands against the seal.
Tighten the screw in the extractor. Remove the seal.
Installation