V70 L5-2.4L VIN 61 B5244S (2004)
(1) = PUR bead.
(2) = Windshield knife
(3) = Locating pin.
Cut along the marked edge.
Use a long blade against the C-post.
Otherwise use a short blade.
Be careful around the locating pin. Do not damage the paint work.
If the window is to be reused: Remove the PUR bead with a chisel.
When working with PUR on the body flange, see PUR on body flange .
Side windows, rear, installing
Note! Install the trim strip before positioning the window when replacing the rear side window.
Install:
-
The trim strip for the V70. See Trim strip on the rear side window
-
The trim strip for the V70XC. See Trim strip on the rear side window .
When working with PUR on the body flange, see PUR on body flange .
Clean the area on the window to which PUR adhesive is to be applied with cleaner-H (black cap).
Apply glass activator (yellow cap) to the area on the glass to which PUR adhesive will be applied.
Apply glass primer (green cap) to the area on the glass to which PUR adhesive will be applied.
Apply generously (although not so much that it runs).
Let the primer dry until the surface is matte.
Apply the PUR/RIM activator (blue cap) on the remaining PUR bead on the body flange.