V70 L5-2.5L Turbo VIN 59 B5254T2 (2004)
NOTE: Ball holder and ball purchased separately.
-
Remove the cover from the towing member.
-
Slide the ball holder into the towing member. Slide until the holes in the ball holder and towing member correspond.
-
Slide the locking bolt into the hole.
-
Lock the other side using the locking pin.
-
Position the ball in the hole on the ball holder.
-
Install washer and nut, torque tighten to 244 Nm (176.5 lbf.ft.).
Storing the ball holder
NOTE: The ball holder, locking bolt and locking pin are purchased separately.
Illustration A applies to the V70
Illustration B applies to the XC70
-
Remove the ball holder. Place the ball holder in the supplied storage bag.
-
Place the bag with the ball holder in the spare wheel. The ball holder must be positioned as illustrated.