V70 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Remove the screws (1) and the bracket (2) from the right side of the rear of the car The bracket will not be used again.
-
Install masking tape on the outside of the bumper to avoid damage from the saw.
Install masking tape opposite the cutting points and over the bumper cover
-
Leave the masking tape in place throughout the installation procedure
-
Cut along the markings for the hole for the connection stud (see the inside of the bumper). Carry out the operation so that the markings remain in
the bumper afterwards
-
After cutting, smooth off the edges using a file.
Installing the detachable tow hitch (including the cable harness)
-
Remove the tow hitch from the cross member. First turn the handle (1) clockwise until a click is heard and the pin (2) is in the outer position. Pull
the tow hitch straight back. Ensure that the shaft is greased.