V70 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Flywheel: Service and Repair
Flywheel
Special tools:
999 5112 GEAR SECTOR See: Tools and Equipment/999 5112 Gear Sector
999 5678 Special screw See: Tools and Equipment/999 5678 Special Screw
Replacing flywheel
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information is always correct.
Removal
Preparations
Remove the transmission.
To remove the clutch: for gasoline see Pressure plate/clutch driven plate, replacing, See: Clutch/Clutch Disc/Service and Repair.
Note! The illustrations display a dual mass flywheel, but the method is the same for cars with a massive flywheel.
Removing the flywheel
Remove the engine speed (RPM) sensor with the bracket. Place it to one side.
Slacken off all the screws for the flywheel. Remove all the screws except for one.
Remove the gear sector 999 5112 GEAR SECTOR See: Tools and Equipment/999 5112 Gear Sector.
Detach the flywheel from the crankshaft. Remove the remaining screw.
Remove the flywheel.
Checking the crankshaft seal
Check the crankshaft seal for leakage.
To replace the crankshaft seal, refer to the car model and year.