V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Carefully drill out the rivets (2) underneath the bumper on both sides. Use a - 6 mm (13/32") diameter drill bit.
-
Remove the screw (1) holding the wheel arch lining for the bumper cover on both sides.
Do not damage any of the plastic components.
Only applies if the car is equipped with clips
-
Remove the clips (1) underneath the bumper cover by pressing in the centre of the clip until a clicking sound is heard. Remove the clips. The clips
shall be re-used.
Applies to all models
-
Pull the bumper backwards slightly. Bend out the sides (2) so that they detach from the mounting (3). Then pull the bumper backwards until it
detaches completely
-
Place the bumper on a clean underlying surface that will not damage the paint.
Only applies if the car is equipped with mouldings
-
Carefully remove the moulding (4) from the expander clips
Illustration B
Applies to cars with parking assistance
