V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Remove the rear wheels.
-
Carefully drill out the rivets holding the mudflap on both sides. Use a Dia. 6 mm (13/32") diameter drill bit.
-
Remove the mudflaps.
Illustration B applies to all cars
-
Carefully drill out the rivets (2) underneath the bumper on both sides. Use a Dia. 6 mm (13/32") diameter drill bit.
-
Remove the screw (1) holding the wheel arch lining for the bumper cover on both sides.
NOTE: Do not damage any of the plastic components.
Illustration A applies to the V70
Only applies if the car is equipped with clips
-
Remove the clips (1) underneath the bumper cover by pressing in the centre of the clip until a clicking sound is heard. Remove the clips. The clips
shall be re-used.
-
Pull the bumper backwards slightly. Bend out the sides (2) so that they detach from the mounting (3). Then pull the bumper backwards until it
detaches completely.