V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Remove the screws (3) on the bracket.
-
Remove the rubber mountings (4). Remove the bracket. The bracket will not be used again.
Illustration B
-
Remove the screws (1). Remove the bracket (2). The bracket will not be used again.
Illustration A applies to the V70 and V70R with chassis number (CH 459000-)
-
Install masking tape on the outside of the bumper to avoid damage from the base of the saw. Install masking tape opposite the cutting points and
over the bumper cover. Leave the masking tape in place throughout the installation procedure.
-
Tape the template to the inside of the bumper as illustrated.
-
Cut out the area as illustrated.
Illustration B applies to the V70 and V70R with chassis number (CH -458999)
-
Use the cutting template from the kit in order to mark the cutting lines on the inside of the bumper. Position the cutting template as illustrated.
-
Carefully mark out the cutting lines around the cutting template.
-
Cut along the markings on the inside of the bumper to make the cut-out for the tow hitch. Cut out so that the marking lines remain in the bumper
